Why is my Klarstein Hot Spring plus leaking hot water?
If your Klarstein Water Dispenser is leaking hot water, it might be because the water level in the inner pot is above the maximum mark. Decrease the water level inside the inner pot.
What to do if Klarstein Hot Spring plus Water Dispenser dispense function does not work?
If the dispense function on your Klarstein Water Dispenser isn't working, check if the dispense function is locked. If it is, press the “Safety Child Lock“ button.
What to do if Klarstein Hot Spring plus dispense function does not work just after boiling?
If the dispense function on your Klarstein Water Dispenser doesn't work right after boiling, the filter might be clogged. Clean the filter with a brush. Alternatively, the dispense function may be affected by bubbles inside the pump. Please open and close the lid once then try again.
Why does my Klarstein Hot Spring plus Water Dispenser have a bad smell after boiling?
A bad smell after boiling in your Klarstein Water Dispenser can occur due to several reasons: - Chlorine in tap water may cause the smell; press the “Reboil“ button to reboil. - The machine oil on the heating element may cause smell in first few use. - If the air pot is used on plastic cloth, smell of plastic may transfer into water.
How to remove white powder from Klarstein Water Dispenser?
The white or glittery powder inside your Klarstein Water Dispenser is likely limescale caused by minerals in the water. Clean the appliance with citric acid.
Hot surfaces during and after use. Do not touch. Allow to cool before cleaning.
Do not handle with wet hands. Do not immerse the appliance in water or liquids.
Identifies key parts like lid, inner pot, control panel, display, outlet, and receiver.
Explains buttons for Reboil, Temp Select, Dispense, Child Lock, and Purified Water.
Details indicators for holding state, fast cooling, temperature, water shortage, and temp decline.
Covers appliance placement, general operation notes, and initial setup steps.
Steps 1 & 2: Filling the inner pot and ensuring the lid is securely closed.
Steps 3 & 4: Connecting to power and starting the reboil function.
Steps 5 & 6: Dispensing water and refilling the tank, including safety lock usage.
Guidelines on boiling water, avoiding steam and hot water hazards.
Procedure to select and adjust keep warm temperatures.
How to unlock and use the dispense function with safety lock.
Instructions for enabling, disabling, and managing the safety lock.
Procedure to enter and exit standby mode to save energy.
How to turn the appliance on/off and manage the reboil function.
Using fast cooling and selecting between tap and purified water modes.
Instructions for cleaning the appliance exterior with appropriate materials.
Guidance on cleaning the water tank, including limescale removal.
Procedure for replacing a damaged or hard seal ring on the lid.
Instructions on how to remove and securely close the top lid.
Addresses problems like white powder, bad smells, and dispensing issues.
Information on proper disposal of electrical equipment according to EU regulations.
General| Type | Water Dispenser |
|---|---|
| Heating Capacity | 5 L/h |
| Power Consumption (heating) | 420 W |
| Hot Water Temperature | 85-95 °C |
| Voltage | 220-240 V |
| Material | Plastic |
| Tank Capacity (cold water) | 0.8 L |
| Cold Water Temperature | 10°C |
| Features | Child Safety Lock, LED Display |
To Next Page