Klarstein Iceblock - Operation; Cooling Mode Operation; Fan and Dehumidification Modes

38
EN
OPERATION
Cooling mode (Cool)
• After switching on the appliance, the cooling mode is set as standard.
• When the cooling mode is selected, the COOL indicator lights up.
• Press the Plus and Minus (Up and Down) buttons to set a temperature between
16°C and 30°C.
• Press the FAN button to set one of the speed modes HIGH, MID and LOW.
Fan mode (FAN)
• After the fan mode is selected with the remote control, the wind indicator lights up.
• Press the FAN button to set one of the speed modes HIGH, MID and LOW.
• The temperature cannot be set.
Dehumidication mode (DRY)
• When the dehumidication mode (DRY) is selected, the DRY indicator lights up.
• Remove the water plug as shown on the right, insert the water pipe (not supplied)
and plug the other end into a water tank or drain.
• In dehumidication mode, the compressor works as follows:
– The compressor starts when the room temperature is above 17°C (62°F).
– When the room temperature is 15 °C (59 °F) or lower, the compressor shuts off.
– When the room temperature rises above 17 °C (62 °F), the compressor restarts
automatically after a 3-minute pause.
• In dehumidication mode, the fan automatically switches to a low speed. The fan
speed and temperature cannot be adjusted in this mode.
Note: It is recommended to remove the exhaust air hose in dehumidication mode.
Otherwise, dehumidication may not work properly or the full water tank („FL“)
alarm will ash on the display.