Klarstein ICEWIND PLUS SMART - WiFi and Filter Maintenance Functions; WiFi Function Notes and Dry Wind Operation

24
EN
Notes on the WiFi function
1. If the unit is switched o again within 10 seconds of being switched on, the
WiFi indicator light returns to the state before it was switched o. If the unit
is switched o after 10 seconds, the WiFi indicator light goes o and the unit
goes into standby mode. Press and hold the setting button for 5 seconds to
restart the function.
2. If no connection to a WiFi network is established within 3 minutes during the
pairing process, the WiFi indicator light goes o. Press and hold the setting
button for 5 seconds to restart the function.
3. If the router is switched o after the connection to the device has been
successfully established, the WiFi indicator light also goes out. When the
router is switched on again, the connection to the device is also automatically
restored.
4. To use the WiFi function, the WiFi indicator on the unit must ash quickly and
the WiFi router must be able to connect to a mobile end device (smartphone).
Dry wind function
• After the cooling and humidication function has been activated, the paper
of the lter's wet curtain must be completely dried. Therefore, always before
storing the unit after using the cooling and humidication function, press and
hold the wind speed button for 3 seconds to activate the dry wind function.
Then stop the dry wind function.
• After the dry wind function has been activated, the next higher wind speed
is selected rst. The appliance then runs for 20 minutes at the highest speed
setting. The indicator light of the highest speed level lights up.
• After activating the dry wind function, the indicator of the highest speed level
ashes and is switched on and o alternately at a frequency of 0.5 seconds.
The function is automatically terminated after 20 minutes.
• When the dry wind function is activated, all other functions are deactivated.
• After this function is activated, all buttons except the on/o button are
deactivated.
• If you press the On/O button before the 20 minutes have elapsed, the
appliance is switched o and the remaining time of the dry wind function is
not saved.
• If the dry wind function has been activated and the unit has been switched
o prematurely, the unit is reset to the previous operating mode when it is
switched on again (except for the timer and sleep mode functions). The dry
wind function is not saved.
• If you switch o the unit after using the cooling and humidication function
without using the dry wind function, you must restart the unit and activate the
dry wind function to dry the paper of the lter wet curtain.