Klarstein ICEWIND PLUS SMART - Cleaning and Maintenance; Cleaning Safety, Exterior, and Filters

27
EN
CLEANING AND CARE
Note: Switch the device o and unplug it before cleaning, repairing or
maintenance.
Cleaning
• If too much foreign matter or dust settles on the grille cover and the air inlet
rotors at the back of the unit, the wind eect will be impaired. It is therefore
recommended to clean them at least every two months.
• Switch o the device and unplug the power cord. Always disconnect the mains
plug before cleaning to avoid electric shocks or mechanical damage.
• Use a commercially available cleaning agent and a soft brush for cleaning. Do
not use chemical cleaners for cleaning.
Cleaning the outer surface of the device
• Wipe the surface with a damp cloth. Do not use water, as it could enter the
unit and damage the electronics.
• Do not use caustic cleaning agents or solvents.
Cleaning the lters
1. Press down the snaps of the dust lter and remove it.
2. Remove the water lter.
3. Vacuum the dust lter.
4. Place the water lter in a warm soap solution for a short time. Then rinse the
water lter thoroughly with clear water. Replace the lters in reverse order.
5. The lter in the water tank can be rinsed with warm water if necessary.