Klarstein Libeica - Before First Use; Making Espresso

22
EN
BEFORE FIRST USE
1. Remove the appliance from the packaging and check that all of the contents
are there.
2. Clean all removable accessories.
3. Use the machine as described in the sections 'Making espresso' and 'Making
cappuccino' (without coee powder in the lter). Repeat this 2-3 times.
4. Remove the red silicone cap from the water tank before using the machine.
MAKING ESPRESSO
For example for 2 cups
1. Open the cover and remove the water tank. Fill the water tank with water up
to the maximum mark. Make sure that the water level does not exceed the
maximum mark.
2. Put the water tank back into the appliance and close the cover.
3. Plug the power plug into the mains socket. The appliance performs a self-test.
The control panel lights up rst and then goes out. The power indicator lights
up red continuously. Press the on/o button. The cup indicator lights ash
red, the steam button lights up red continuously and the appliance heats
up. After about one minute, both button indicators light up red, the steam
indicator lights up red and preheating is complete.
4. Remove the lter holder and use the coee spoon to put the appropriate
amount of coee (15-17 grams) into the lter. Press the coee down rmly.
Remove excess coee powder from the rim to avoid damaging the sealing
ring of the brew group head.
Note: If too much coee powder remains on the edge of the lter, this can lead
to an insucient seal and water leaking out.
Water tank
Red silicone cap