Klarstein Libeica - Troubleshooting

29
EN
6 Press the coee button again (without adding coee powder) and repeat step
4 3 times (without waiting 15 minutes). Then brew coee (without adding
coee powder) until there is no more water in the water tank.
7 Repeat step 6 at least 3 times to ensure that the lines are free of residues.
TROUBLESHOOTING
Problem Possible cause Solution
No water comes out. The water tank is empty. Fill up the water tank.
The input current does
not match the voltage
indicated on the type
plate.
Make sure that the input
voltage corresponds to
the voltage indicated on
the type plate.
Appliance
malfunctioning
Contact customer
service.
No steam is produced. The steam nozzle is
clogged.
Clean the steam nozzle.
The water tank is empty. Fill up the water tank.
Appliance
malfunctioning
Contact customer
service.
Coee runs out over the
edge of the lter holder.
Too much coee powder
in the lter
Switch o the appliance
and wait until it has
cooled down. Clean the
lter and ll it with the
appropriate amount of
coee powder.
There is coee powder
under the sealing ring.
Remove the coee
powder from the sealing
ring.
The sealing ring is
damaged/leaking.
Contact customer
service.