2
GENERAL SPECIFICATIONS
Klein Tools ET180 is designed to measure the pressure for ports P1, P2,
and the differential pressure individually for air and gas pressures. The
meter features a magnet in back for hands-free operation.
• Environment: Indoors
• Sensor Type: Gauge manometer/dual sensors with temperature
compensation
• Range: +/- 60 inH
2
O
• Accuracy: +/- 1.5% FS at 25°C
• Measurement units: bar, oz/in
2
, psi, mbar, kPa, inHg, mmHg,
kg/cm
2
,inH
2
O, ftH
2
0, and cmH
2
O
• Auto Power Off (APO): After 15 minutes of inactivity
• Tubing: 1/8" ID × 6.56' (3mm ID × 2m) silicon tubing included
• Batteries: 3× AAA alkaline
• Operating Altitude: 6562 ft. (2000 m)
• Relative Humidity: <85% non-condensing
• Operating Temp: 32° to 122°F (0° to 50°C)
• Storage Temp: 14° to 140°F (-10° to 60°C)
• Dimensions: 6.19" × 2.47" × 1.38" (157 × 63 × 35 mm)
• Weight: 7.2 oz. (202 g) including batteries
• Standards: Conforms to EN 61326-1:2013; EN61326-2-3:2013
Specifications subject to change.
WARNINGS
To ensure safe operation and service of the tester, follow these
instructions. Failure to observe these warnings can result in severe
injury or death. Know the characteristics of the gas you are working
with and use proper precautions to avoid hazardous conditions.
• Read, understand, and follow all instructions to ensure safe operation.
• The meter is NOT insulated. Avoid contact with areas where energized
conductive elements may be present. Shut off power to the area before
starting measurements.
• Always wear approved eye protection.
ENGLISH
SYMBOLS ON METER
Warning or Caution Magnet Location
Wear Approved
Eye Protection
Conformité Européenne:
Conforms with European
Economic Area directives
NOT insulated - Will NOT
protect against electric shock
UKCA - UK Conformity
Assessment
Strong Magnetic Field WEEE – Electronics disposal
Read Instructions Battery Type and Orentation
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
