5
ELECTRICAL SPECIFICATIONS
• Diode Test: 1.5 mA max, open circuit voltage 3.0V DC
•
Continuity Check:
Audible signal <50Ω
• Sampling Frequency:
3 samples per second
• Overload:
"OL" indicated on display
, overload protection
600V RMS in all settings
•
Polarity:
"-" on display indicates negative polarity
• Display:
3 ¾ digit, 4000 Count LCD
WARNINGS
To ensure safe operation and service of the meter, follow these
instructions. Failure to observe these warnings can result in
severe injury or death.
• Before each use verify meter operation by measuring a known
voltage or current.
• Never use the meter on a circuit with voltages that exceed the
categor
y based rating of this meter.
•
Do not use the meter during electrical storms or in wet weather
.
• Do not use the meter or test leads if they appear to be damaged.
• Use only with CA
T III or CAT IV rated test leads.
• Ensure meter leads are fully seated, and keep fingers away
from the metal probe contacts when making measurements.
• Do not open the meter to replace batteries while the probes
are connected.
• Use caution when working with voltages above 25V AC RMS
or 60V DC. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock,
replace batteries when a low batter
y indicator appears.
• Do not attempt to measure resistance or continuity on a live
cir
cuit.
• Always adhere to local and national safety codes. Use personal
protective equipment to prevent shock and ar
c blast injur
y
where hazardous live conductors are exposed.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
Weight and Dimensions
