Dwg Name: TI290-1390506ART
Dwg No: 1390506
ECO No: 44944 Rev: A
Pkg Dwg Ref: 1290186
Finish Coat Requirements: N/A
4
ENGLISH
COMPLIANCE
FCC COMPLIANCE
This device complies with part 15 of the FCC RULES. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received,including interference that may cause
undesired operation.
NOTE: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
FCC RF EXPOSURE STATEMENTS:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment and meets the FCC RF
Exposure Guidelines.
This device must not be co‐located or operated in conjunction with
any other antenna or transmitter.
COMPLIANCE
IC COMPLIANCE
This device contains license-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development
Canada’s license-exempt RSS(s). Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation
of the device.
This device complies with RSS-247 of Industry Canada. Operation
is subject to the condition that this device does not cause harmful
interference. This Class B digital apparatus complies with Canadian
ICES-003.
IC RADIATION EXPOSURE STATEMENT:
The equipment complies with SAR limits set forth for an
uncontrolled environment and meets the RSS-102 of the IC
RF Exposure Rules. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
EU DECLARATION OF CONFORMITY
Hereby, Klein Tools declares that this product is in compliance with
Directive 2014/53/EU and all other applicable EU requirements. The
complete declaration of conformity can be found on this product’s
page at www.kleintools.com.
UKCA DECLARATION OF CONFORMITY
Hereby, Klein Tools declares that this product is in compliance
with the relevant statutory requirements. The complete
declaration of conformity can be found on this product’s page
at www.kleintools.com.
TI290-1390506ART.indd 4TI290-1390506ART.indd 4 6/29/2022 5:24:06 PM6/29/2022 5:24:06 PM
To Next Page
Loading...
