9
KR 702- 2 / Serial no. 1910404/2008
2 Extreme environmental condition
If the drill rig is to be operated under extreme or outside the of KLEMM Bohrtechnik
specified site conditions, previous clarification with KLEMM Bohrtechnik is necessa-
rily. These are e.g.:
- Extremely low or high temperatures and or humidity
- Special geographical altitudes
- Particularly high dusty condition
- Operations in tunnels or underground
3 Changeable equipment
3.1 Equipment from KLEMM Bohrtechnik
For the drill rigs of KLEMM Bohrtechnik many equipment components, which can
be changed or additional mounted are available.
For example these are rotary drill heads, hydr. drifters, rod magazines, drill masts
and drill mast extensions, flushing pumps, lubricants and fuels and other compo-
nents. All combinations of changeable equipment with the drill rig cannot be descri-
bed. To avoid endangerments and damages, the following points must be strictly ob-
served when self changes of the drill rigs equipment are made:
- permissible stabilities und strengths
- permissible pressures in the hydraulic system
- permissible flow rates in the hydraulic system
- permissible operation modes of hydraulical and electrical components
(e.g. preferred rotation direction of hydraulic motors)
- electrical control- and monitoring functions
- use of safety devices or safety components
- permissible contamination for lubricants and operating materials
- conformity with the european regulation for machines when substantial
changes are done (only in the marketing area of the European union).
3.2 Adaptation at or of equipment of other manufacturers
Fundamental the same points as being considered above are to be observed.
The adaptations takes place in the discretion of the operator if they are not coordina-
ted with KLEMM Bohrtechnik.
In principle the in the manual and further attached documentation
contained safety and warning reference must be observed.
If there is none or a contradictory information to a specified question in
the documentation, KLEMM Bohrtechnik must be consulted before
operation or conversion.
To Next Page
Loading...
Need help?
General