KLIPPO LAWNMASTER - User Manual

Questions and Answers

I
Ian FrancoAug 5, 2025
What to do if my KLIPPO LAWNMASTER Lawn Mower leaves some uncut grass?
- K
  Kevin RamosAug 5, 2025
  If your KLIPPO Lawn Mower exhibits some uncut or poorly cut strands of grass, this may be due to several reasons. The cutting cylinder might be partially or heavily out of contact with the bottom blade, requiring a readjustment. Alternatively, the height of cut could be too high, necessitating a lower setting. Lastly, the cutting edges of the cutting cylinder or bottom blade could be rounded, which means they need grinding.
A
Abigail DavisAug 10, 2025
Why does my KLIPPO LAWNMASTER leave lines of uncut grass?
- J
  jeffreymezaAug 10, 2025
  If your KLIPPO Lawn Mower shows lines of uncut or badly cut grass in the direction of travel, it could be due to several factors. The cylinder might be too tightly adjusted to the bottom blade, causing damage, which requires grinding the cutting edges. The bottom blade might be in ground contact, so you should raise the height of cut. The bottom blade might have a ‘nose down’ attitude, so readjust the height of cut. The undulations might be too severe for the height of cut setting, so raise the height of cut.
S
Samuel ContrerasAug 16, 2025
How to prevent scalping with my KLIPPO LAWNMASTER?
- N
  nguyenmichaelAug 16, 2025
  If your KLIPPO Lawn Mower is scalping, it is likely that the undulations are too severe for the current height of cut setting. To resolve this, raise the height of cut.
J
Julie HayesAug 22, 2025
Why does my KLIPPO LAWNMASTER Lawn Mower leave ridge lines?
- G
  george62Aug 23, 2025
  If your KLIPPO Lawn Mower is showing ridge lines in the cut across the direction of travel, it could be because the forward speed is too high, requiring a reduction in engine rpm. Alternatively, the cylinder speed might be too slow, so reduce forward speed. It may also be that the height of cut is too low, so raise the height of cut.
J
Jeffrey MckayAug 28, 2025
What causes excessive bottom blade wear on my KLIPPO LAWNMASTER?
- V
  vschwartzAug 28, 2025
  Excessive bottom blade wear in your KLIPPO Lawn Mower can occur for several reasons. The bottom blade might be in heavy ground contact, so raise the height of cut. The cutting edges of the cutting cylinder or bottom blade might be rounded, so grind the cutting edges. The cutting cylinder might be in heavy contact with the bottom blade, so readjust the cutting cylinder to the bottom blade. The cutting cylinder or bottom blade might be damaged, so regrind or replace if necessary.