KDA AMPLIFIERS – DSP MENU USER GUIDE
SECTION 2 : DSP MENU PAGES
“FLASH AMP LED” COMMAND
When activated, this button will flash
the front LEDs on the amplifier you are
connected to. This is helpful in
situations when multiple amplifiers are
racked.
POWER CONFIGURATION
POWER MODE:
Always On - Stays on until hard power
switch is turned off.
External Trigger - Senses input trigger
from 12V trigger input on back panel
Auto On - Amplifier auto detects signal
from input source
AUTO ON THRESHOLD: Sets sensitivity
to input signal for auto turn-on.
TURN ON DELAY: Delays turn on from
initial signal detection - useful for
specific power sequencing
AMPLIFIER NAME
Customize amplifier name.
8
To Next Page
Loading...
