11
BLUETOOTH OPERATION
The KMC2 includes built-in Bluetooth technology that allows you to wirelessly
connect Bluetooth devices to this head unit for streaming audio playback.
About Bluetooth Technology
Bluetooth is a short-range wireless radio protocol. Operating in the 2.4 GHz
range, it transmits voice and data at speeds up to 2.1 Mbit/s over a range of up to
10 meters.
Bluetooth Menu Options
NOTE: Please note that some BT menu options are only available while the
unit is in BT Audio mode
Press and hold the MENU button (2) to enter menu adjustment mode. Rotate the
Encoder Knob (3) to navigate the menu list to “Bluetooth Setup” and press the
Encoder Knob to access the following Bluetooth Menu options:
• BT ON/OFF: Rotate the Encoder Knob to choose “BT ON” or “BT OFF”,
and then press the Encoder Knob button to enter the selection.
• BT DEVICE LIST: Press the Encoder Knob button to view devices from the
list Rotate the Encoder Knob to view a list of previously paired mobile
devices. Press the Encoder Knob button to select the device. Rotate the
Encoder Knob to choose Lock/Unlock, Disconnect or Delete for this device.
You cannot delete a device that is actively connected.
• LOCK/UNLOCK: The KMC2 can store up to 5 devices for BT connection.
The devices are stored in FIFO (First in First Out) order. To prevent a
device from being bumped from the list when more than 5 devices are used,
you must lock the device. To Lock/Unlock a device, press the Encoder
Knob button to display/change the Locked or Unlocked icon.
• DISCONNECT: To disconnect a paired device, press the Encoder Knob
button to temporarily remove the BT link. The link can be re-established
through your phone menu by selecting the KMC2 for connection.
• DELETE: To delete a device from the list, press the Encoder Knob button.
• BT PAIR: Rotate the Encoder Knob to choose “Pair?”, then press the
Encoder Knob button to start pairing mode.
Pairing a Bluetooth Device
Before you begin, consult the owner’s manual for the Bluetooth device you want
to pair with the KMC2.
Make sure the device you intend to pair with is on and ready to pair.
1. First, put the KMC2 into Bluetooth mode.
2. Press the PAIR soft button (6) to start Bluetooth pairing process.
3. The KMC2 will display “Pairing...” and will be available to pair for 120
seconds.
4. In your device Bluetooth settings, select "KMC2” to pair and connect.
Receiving a Call While Listening to Music
When answering a call using a connected phone, BT AUDIO will pause. After
hanging up from the call, BT AUDIO will continue on some phones. It may be
necessary to press the play button to resume BT AUDIO.
BT Audio (A2DP)
When connected, a Bluetooth enabled device is able to stream audio to the
KMC2. To access Bluetooth mode and play songs stored on your phone, press
the MODE button (5). While in BT mode, the BT AUDIO icon illuminates on the
LCD.
Selecting Tracks
During playback, press the |<< or >>| soft buttons to play the previous or next
track.
To Next Page
Loading...
Need help?
General
