6
TUNER OPERATION
Tuner mode options available are TUNE, BAND, PSET and PTY.
BAND
Select a Band
Press the BAND soft button (8) to change between FM or AM bands.
TUNE
Manual Tuning
Press the TUNE soft button (7). Press the |<< or >>| soft buttons to decrease/
increase stations down / up step by step.
Seek Tuning
Press and hold |<< or >>| soft buttons to automatically seek the next or previous
strongest broadcast station.
PRESETS
Press the PRESET soft button (6) to access List, Scan, and Autosave.
LIST
Press the LIST soft button (6) to display the preset list. There are 18 FM and 12
AM preset locations to store your favorite broadcast stations.
SCAN
Press the SCAN soft button (7) to scan stations stored in the current band list.
The unit will pause for ten seconds at each preset station. Press SCAN again to
stop scanning when the desired station is reached.
AUTOSAVE
Press the AUTOSAVE soft button (8) to automatically select strongest stations
and store them in the preset list for the selected Band. The new stations replace
any stations already stored in that band.
Store a Station
While tuned to the desired broadcast station, press the PRESET soft button (6)
and then the LIST soft button. Rotate the Encoder Knob (3) to navigate the
preset list and highlight the desired preset memory location. Press and hold the
Encoder Knob for 3 seconds or press the SAVE soft button (6) to store the
station. The station frequency will appear in the display adjacent to the preset
memory location number.
Recall a Station
Rotate the Encoder Knob to navigate the preset list and highlight the desired
preset memory location. Press the Encoder Knob to select and tune to the
corresponding stored station.
To Next Page
Loading...
Need help?
General
