5
System Menu
1. Press and hold the MENU button (2) for more than 3 seconds to enter the
system menu. “SYSTEM SETTINGS” will appear on the display, followed by
the first menu item, “Key Beep.”
2. Rotate the Encoder Knob (3) to navigate the system menu and highlight
the desired item.
3. Press the Encoder Knob to select the item and rotate the Encoder Knob
to adjust the selected menu item.
4. Press the Encoder Knob again to enter your selection and return to the
menu list.
5. Press the back arrow soft button (9) to return to the previous operation.
6. The following items can be adjusted:
• Key Beep (On/ Off)
• LCD Backlight (1 – 10)
• LCD Backlight Night (1 – 10)
• LCD Contrast (1 – 10)
• Button Backlight (1 – 10)
• Button Backlight Night (1 – 10)
• Power Button Backlight (1 – 10)
• Tuning Region (USA/ Europe)
• Bluetooth Setup (Sub Menu, only accessible in Bluetooth mode)
- BT ON/OFF: Choose “BT ON” or “BT OFF”.
- BT PAIR (ON/OFF): Choose “YES” to automatically pair a previously
paired device.
- BT DEVICE (Lock/Unlock, Disconnect/Connect, Delete): View, lock
and delete from a list of previously paired mobile devices.
• Battery Alarm (On/Off)
• Battery Auto Off (On/Off)
• Firmware: Press the Encoder Knob to view software version
information.
• Reset to Defaults: Press Encoder Knob once to confirm. (Resets unit
to factory default settings)
7. The system will automatically exit this menu after 10 seconds of inactivity.
NOTE: BT Pair and BT Device menu options are only available while in the
BT mode.
Battery Alarm Operation
If Battery Alarm is set to “ON”, an alarm will sound (3 beeps every 30 sec) when
the voltage drops to 10.8V (+/- 0.3V). A visual warning (Battery Low) will appear
flashing on the LCD display.
NOTE: “OFF” is the default setting for Battery Alarm. If the audio is muted
or the volume is set to 0, the audible beep will not be heard.
Liquid Crystal Display (LCD)
The current frequency and activated functions are shown on the LCD panel.
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility of the
numbers on the LCD may decrease slightly. The LCD display will return to
normal when the temperature increases to a normal range.
Back Key (swoop arrow)
In various modes and conditions, the swoop arrow option will be available in the
lower right soft button. Press button to exit the current operation without waiting
for the system default time out and returning to the previous menu display.
To Next Page
Loading...
Need help?
General
