Klipsch KMC2 User Manual

KMC2
4
BASIC OPERATION
Power On/Off
Press the POWER button (1) to turn the unit on. Press and hold to turn the unit
off.
Dimming Feature
Press the POWER button (1) when the unit is on to switch between user set
day/night setting. Day/night setting is located in the system settings.
Volume
To increase the volume, rotate the Encoder Knob (3) clockwise. To decrease the
volume, rotate the Encoder Knob counter-clockwise.
Mute
When in live audio mode (AM/ FM/ Weatherband), press the ►II button (4) on the
control panel to mute the audio output. Press ►II button again to restore the
audio output to the previous level.
Mode
Press the MODE button (5) on the control panel to enter mode selection display.
Rotate the Encoder Knob (3) to desired mode and press to make selection.
Audio Menu
Press the MENU button (2) on the control panel to access the audio menu. You
can navigate through the audio menu items by rotation the Encoder Knob and
pressing the Encoder Knob to make selection. The unit will automatically exit the
audio menu after 10 seconds of inactivity. The following menu items can be
adjusted.
Bass Level
Use the Encoder Knob to adjust the Bass level range from “-6” to “+6”.
Treble Level
Use the Encoder Knob to adjust the Treble level range from “-6” to “+6”.
Balance
Use the Encoder Knob to adjust the Balance between the left and right
speakers from “L12” (full left) to “R12” (full right).
Fade
Use the Encoder Knob to adjust the Fade between the front and rear
speakers from “F12” (full front) to “R12” (full rear).
Subwoofer
Use the Encoder Knob to adjust the Subwoofer level range from “0” to “40”.
Loudness
Press the LOUD soft button to toggle loudness on/off. When listening to
music at low volumes, this feature will boost the bass and treble ranges.
Zones
This unit may come from the factory in various Zone configurations or
without zone capabilities. Settings may vary based on factory configuration.
The unit connects to KMC1DSP using the JDAB 4 pin and Differential 6 pin
connectors. Press the Menu button (2) on the control panel to access the
audio settings menu, and then press the (7) button to enter Zone Settings.
Rotate the Encoder Knob to select Zone and then press the Encoder Knob
to select a Zone. Rotate the Encoder Knob to adjust Zone volume. Press
the Encoder Knob again to confirm the volume level.

Klipsch KMC2 Specifications

General

Brand	Klipsch
Model	KMC2
Category	Stereo System
Language	English