Connecting the loudspeakers - 2
The P 39-F Terminal Panel
As supplied positive and negative terminals of the Treble, Midrange and Bass Terminal pairs are strapped
together with a three way strap. A pair of two way straps is provided in the accessories carton for bi-wiring. This
is how you should prepare the terminal panel for each wiring option.
Standard (Single) Wiring
The straps are left in place as supplied. Connection may be made to any pair of terminals.
You will need two loudspeaker cables of equal lengths, one for each loudspeaker.
Partially unscrew one Positive and one Negative terminal Connect the Positive + RED terminal of the
loudspeaker to the striped conductor or (if you are using custom cable) to the conductor designated by the
cable manufacturer. Connect the Negative – BLACK terminal to the plain conductor. Do not connect the
amplifier at this time.
Important Note. After connecting and placing the loudspeaker upright the connections will be hidden from
view. We strongly recommend that you identify each cable to eliminate possible difficulties down the line.
AMPLIFIER
RIGHT SPEAKER
LEFT SPEAKER
HFHF
MFMF
LFLF
HFHF
MFMF
LFLF
Standard Connection
HFHF
MFMF
LFLF
Bi-Wiring Connection Tri-Wiring Connection
No preparation
needed
Loosen the terminals.
Remove the triple straps and insert
the twin straps as shown
Re-tighten all terminals hand tight
Loosen the terminals.
Remove the triple straps
Re-tighten all
terminals hand tight
HFHF
MFMF
LFLF
HFHF
MFMF
LFLF
Page 9
To Next Page
Loading...
Need help?
General