Klipsch RSB-6 Firmware Update Instructions

As the update installs - the Virtual Surround Mode
LED will light up, then the Dialog LED, then the
Night Mode LED. The update will be complete once
all 4 LED’s are lit.
RSB-6 SOUND BAR FIRMWARE UPDATE INSTRUCTIONS
Problems or questions?
Enter this url into your web browser -
http://support.klipschgroupinc.com/
...and click on the “Open a New Ticket” button.
Remove the USB flash drive from the sound bar.
Unplug the power cord from the sound bar.
9
Plug the power cord into the sound bar. Your
sound bar firmware is now up to date and your
sound bar should operate normally.
10
8
Soundbar
7

Klipsch RSB-6 Specifications

General

Audio Channels	2
Subwoofer	included
Surround Sound	dolby digital
High Resolution Audio	yes
Dialogue Enhancement	no
Number of Drivers	4
Video Pass-through	2160 (4k)
Tweeters	1
Maximum Frequency Response	15 kilohertz
Minimum Frequency Response	30 hertz
Inputs	3.5mm audio, hdmi, optical digital audio
Outputs	hdmi
HDMI Inputs	1
HDMI Outputs	1
HDMI ARC Ports	yes
HDMI HDCP 2.2 Inputs	1
HDMI HDCP 2.2 Outputs	1
USB Ports	0
Bluetooth	yes
Wireless Connectivity	bluetooth, wi-fi
Wireless Subwoofer Connectivity	no
Wireless Multi-Room Audio	no
Optical Audio Inputs	1
Remote Control	yes

Weight and Dimensions

Depth	3.8 inches
Height	3.8 inches
Width	40 inches
Net Weight	6.5 pounds
Subwoofer Depth	13.5 inches
Subwoofer Height	10.5 inches
Subwoofer Width	7.375 inches
Subwoofer Weight	9.6 pounds