KMC Controls BAC-9001

2
1
NOTE: The V-clamp nuts
3
should be on top.
3
2. Turn the controller over.
3. Remove the stop screw
4
from the storage
location and clean any debris from the
threads.
4
4. Insert the stop screw into the 60
5
or 45
6
stop hole position.
BAC-9000 Series VAV Controller
Installation Guide
INTRODUCTION
Complete the following steps to install a KMC
Conquest™ BAC-9000 Series VAV Controller-
Actuator. For controller specications, see the
data sheet at kmccontrols.com. For additional
information, see the KMC Conquest Controller
Application Guide.
SET DRIVE HUB (45/60°) ROTATION LIMIT
NOTE: Complete the steps in this section if
the VAV damper rotation limit is either
60 or 45 degrees.
NOTE: If the VAV damper rotates 90 degrees,
skip this section and go to Mount
Controller on page 2 instead.
1. Push and hold the gear release
1
and rotate
the drive hub and V-clamp
2
to the left.
KMC Controls, 19476 Industrial Drive, New Paris, IN 46553 / 877.444.5622 / Fax: 574.831.5252 / www.kmccontrols.com
CONTENTS
Introduction .............................................. 1
Set Drive Hub (45/60°) Rotation Limit ............ 1
Mount Controller ........................................ 2
Connect Sensors and Equipment .................. 3
Connect (Optional) Pressure Sensor.............. 4
Connect (Opt.) Ethernet Network .................. 4
Connect (Optional) MS/TP Network............... 5
Connect Power .......................................... 5
Power and Communication Status ................. 6
MS/TP Network Isolation Bulbs .................... 6
Watch Dog Jumper ..................................... 7
Congure/Program the Controller ................. 7
Sample (BAC-9001) Wiring .......................... 8
Replacement Parts ..................................... 9
Important Notices ...................................... 9

KMC Controls BAC-9001 Specifications

General

Controller Type	BACnet Advanced Application Controller
Enclosure Rating	IP20
BACnet Protocol	BACnet MS/TP
Communication Ports	RS-485
Power Supply	24 VAC/DC
Inputs	8 Universal Inputs
Operating Temperature	0°C to 50°C
Outputs	8 Universal Outputs (0-10 VDC)

Summary

Introduction

Set Drive Hub (4560) Rotation Limit

Mount Controller

Connect Sensors and Equipment

Connect (Optional) Pressure Sensor

Connect (Opt.) Ethernet Network

Connect (Optional) MSTP Network

Connect Power

Power and Communication Status

Green READY LED Status

Indicates normal operation after power-up/initialization, flashing about once per second.

Amber MSTP COMM LED Behavior

Flickers during normal operation, slower flash when not connected or communicating.

Green ETHERNET LED Status

Stays ON when communicating with the network, OFF when not communicating.

Amber ETHERNET LED Behavior

Flashes for 100BaseT communication, OFF for 10 Mbps communication.

MSTP Network Isolation Bulbs

Watch Dog Jumper

ConfigureProgram the Controller

Sample (BAC-9001) Wiring

Replacement Parts

Important Notices