KMC Controls BAC-9001CE User Manual

2
1
NOTE: The V-clamp nuts
3
should be on top.
3
2. Turn the controller over.
3. Remove the stop screw
4
from the storage
location and clean any debris from the
threads.
4
4. Insert the stop screw into the 60
5
or 45
6
stop hole position.
BAC-9000 Series VAV Controller
Installation Guide
INTRODUCTION
Complete the following steps to install a KMC
Conquest™ BAC-9000 Series VAV Controller-
Actuator. For controller specications, see the
data sheet at kmccontrols.com. For additional
information, see the KMC Conquest Controller
Application Guide.
SET DRIVE HUB (45/60°) ROTATION LIMIT
NOTE: Complete the steps in this section if
the VAV damper rotation limit is either
60 or 45 degrees.
NOTE: If the VAV damper rotates 90 degrees,
skip this section and go to Mount
Controller on page 2 instead.
1. Push and hold the gear release
1
and rotate
the drive hub and V-clamp
2
to the left.
KMC Controls, 19476 Industrial Drive, New Paris, IN 46553 / 877.444.5622 / Fax: 574.831.5252 / www.kmccontrols.com
CONTENTS
Introduction .............................................. 1
Set Drive Hub (45/60°) Rotation Limit ............ 1
Mount Controller ........................................ 2
Connect Sensors and Equipment .................. 3
Connect (Optional) Pressure Sensor.............. 4
Connect (Opt.) Ethernet Network .................. 4
Connect (Optional) MS/TP Network............... 5
Connect Power .......................................... 5
Power and Communication Status ................. 6
MS/TP Network Isolation Bulbs .................... 6
Watch Dog Jumper ..................................... 7
Congure/Program the Controller ................. 7
Sample (BAC-9001) Wiring .......................... 8
Replacement Parts ..................................... 9
Important Notices ...................................... 9

KMC Controls BAC-9001CE Specifications

General

Brand	KMC Controls
Model	BAC-9001CE
Category	Controller
Language	English

Summary

Introduction to BAC-9000 Series VAV Controller

Set Drive Hub Rotation Limit

Configures the VAV damper rotation limit to 45 or 60 degrees.

Mount Controller

Connect Sensors and Equipment

Connect Optional Pressure Sensor

Connects an air flow sensor using pressure tubing to the controller.

Connect Optional Ethernet Network

Connect Optional MS/TP Network

Connects the controller to a BACnet MS/TP network using twisted pair cable.

Connect Power

Power and Communication Status LEDs

Explains the status LEDs for power, network, and communication.

MS/TP Network Isolation Bulbs

Watch Dog Jumper

Configure/Program the Controller

Sample Wiring Diagram

Replacement Parts Information

Important Notices and Disclaimers