Need help?Do you have a question about the KMC Controls KMD-7001 and is the answer not in the manual?
General| Brand | KMC Controls |
|---|---|
| Model | KMD-7001 |
| Category | Controller |
| Language | English |
Introduces the KMD-7001, 7002, 7003 controllers and illustrates their components and connection details.
Details initial preparation steps, including setting rotational limits using stop pins for actuator travel.
Explains how to mount the controller onto the damper shaft and adjust the drive hub for proper operation.
Covers wiring procedures and the use of the removable conduit plate for connecting wires to the controller.
Details how to make universal and RS-485 input connections to the controller terminals.
Describes airflow sensor input, controller outputs, RJ-12 port, and board configuration settings.
Details how to connect the 24 VAC power supply to the controller's power terminal block.
Outlines the necessity of configuring the controller using HCM for network communication and addressing.
Refers to the KMC Digital Applications Manual for information on how to program the controller.
Describes controls like the network ON/OFF switch and indicators like Status LEDs and Isolation Lamps.
Provides step-by-step instructions to reset the controller to factory default configuration using the RST jumper.
States that the document content is for informational purposes and subject to change without notice.
Provides contact information for technical support regarding the document and products.
To Next Page
