504G3 SERIES TRACTOR OPERATION MANUAL
28
3.3 Running in of hydraulic hitch system
1. Attach ballast or implement whose weight is 800Kg to 3 point hitch system. Push
the position control lever forward all the way to its lower position.
2. Run the engine in low speed for 10 min and in high speed for 10 min.
3. Pull the position control lever backward all the way to its max lift position. Then
control the draft control lever to make the ballast or implement moving from highest
position to lowest position for 10 times.
4. Place the draft control lever in its lowest position. Then control the position control
lever to make the ballast or implement moving from highest position to lowest
position for 10 times. Check whether the position control lever in any position
needed.
5. If hydraulic system operate hardly and lift or low hardly, check trouble immediately.
3.4 Running-in of hydraulic steering system
(1)Park the tractor on the flat road.
(2) Start the engine , let the engine work in low speed, mid speed and high speed. Turn
the steering wheel left and right steady in proper order to do ten times pivot steering.
Check whether the steering is flexible and portable. Check whether the steering system
has oil leak, oil infiltrate and abnormal noise. During the Running-in of hydraulic
steering system, the malfunction should be eliminated in time.
(3) After the engine shutdown, turn the steering left and right slowly , observe the
follow-up condition of tractor front wheel steering to check whether it can realize the
manpower turn .When turning the steering ,do not apply impact force to the steering
wheel.
3.5 Running in of PTO
Put the throttle handle of engine into medium position, the engine will run in idle speed,
switch on the PTO switch to engage PTO clutch. Let the PTO shaft running-in for 5
minutes respectively at low speed and high speed by shifting PTO lever to “LOW” or
To Next Page
Loading...
