KNEGT 504G3 Series - 3.6 Running in of the Tractor

504G3 SERIES TRACTOR OPERATION MANUAL
29
“HIGH” position. Check if it is abnormal and must make PTO shaft at Netural position
after running-in.
3.6 Running in of the Tractor
When operating the tractor with a load during the running-in process, the load must be
added from light to heavy and the gears must be changed gradually from low to high.
Also you must steer and turn the tractor often while performing the above procedures.
The total time needed to running-in the tractor with a load is 50 hours. The running-in
criteria are as follows:
Gear
Draft( KN) To
tal
time(h)
Without
load
2.5 5 7.5
Time
(h)
Forward
L
Ⅰ
0.5 1 1.5 1
52
Ⅱ 0.5 1 1.5 1
Ⅲ 0.5 1 1.5 1
Ⅳ 0.5 1 1.5 1
M
Ⅰ
0.5 1 1.5 0.5
Ⅱ 0.5 1 1.5 0.5
Ⅲ 0.5 1 1.5 0.5
Ⅳ 0.5 1 1.5 /
H
Ⅰ
0.5 1 0.5 /
Ⅱ 0.5 1 / /
Ⅲ 0.5 1 / /
Ⅳ 0.5 1 / /
Reverse L
Ⅰ
1 1 0.5 0.5
Ⅱ 1 1 0.5 0.5
Ⅲ 1 1 0.5 0.5
Ⅳ 1 1 0.5 0.5
Creeper L Ⅰ 0.5 1 1 0.5