KNEGT 504G3 Series - 6.3 Adjustment of the Brake

504G3 SERIES TRACTOR OPERATION MANUAL
71
same time, screw the adjusting nut 3, adjust the pull rod head part 2 to insure the pedal
free path be in the stated range, then tighten the adjusting nut 3, make the hole of the
pull rod head part right at the proper place, at last, mount the shaft, washer and the split
pin..
6.3 Adjustment of the Brake
Fig 6-2
1. Adjusting nut A 2. Pull rod head part A 3. Adjusting nut B 4. Pull rod head part B
5. Adjusting nut C 6. Adjusting nut D