KNEGT 504G3 Series - Page 39

504G3 SERIES TRACTOR OPERATION MANUAL
37
indicator switch.
Push down horn switch 2 to swith on horn. The button 2 will return to initial postion
after releasing.
Turn main beam switch 3 to control the main beam lamp.
4、Switch plate：
Fig.4-6 Switch plate
1. Hazard-warning signal Switch
2. PTO Switch
3. Rear Work Lamp
(1) Hazard-warning signal switch
It is only used to switch ON the hazard-warning signal.
Hazard-warning signal should light when tractor should be
repaired on road or running in night. “1” is ON position.
(2) PTO Switch
It is only used to engage PTO. When the speed of PTO shaft
Should be changed, place switch on “0” position where
PTO is disengaged.
(3) Rear Work Lamp Switch
It is only used to switch on the
rear work lamp. “1” is ON
position. Rear work lamps are
installed on left and right
fenders.
Fig.4-7
1. Rear Work Lamp
0
1
1
0
PTO
0
1