EasyManua.ls Logo

KNEGT 504G3 Series - Page 46

KNEGT 504G3 Series
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
504G3 SERIES TRACTOR OPERATION MANUAL
44
NOTE:If temperature is below 5℃,refer to cold weather starting procedure in START
IN COLD WEATHER section.
(1) Pull hand throttle backward to about mid of lever travel to increase engine
speed.Engine does not start with throttle pushed up.
CAUTION:
1) Avoid possible injury or death for the sake of a machine runaway. Do not start
engine by shorting across starter terminals.If normal circuitry is by passed,machine
starts in gear and moves.
2) Start engine only from seat with transmission in neutral.Never start engine while
standing on ground.
IMPORTANT: Do not run a cold engine at full throttle.
(2) Make certain Shuttle shift lever in Neutral, N position, and creeper gear shift lever
in Highposition, and the PTO switch in OFF position.Depress clutch pedal and turn
key in ignition switch fully clockwise to START position.Release key when engine
starts.If key is released before engine starts, wait until starter and engine stop
turning before trying again.Check all indicators are off after engine starts.
IMPORTANT:DO NOT operate starter more than 15 seconds at a time.If engine
does not start,wait at least 2 minutes for starter motor to cool before trying again.If
engine does not start in three attempts,refer to TROUBLE SHOOTING section.
Start in Cold Weather
CAUTION: Never use any starting fluid when starting the engine using the cold
weather starting aid.The heating coil in the device may cause such flammable material
to ignite, result in bodily harm or damage to machine.
(1) Proceed as instructed in Before Starting the Engine and up to starting the Engine,
step 1, in this section.
(2) Turn ignition key clockwise to Preheat position, hold key in this position in
between 20-25sec, then turn key fully clockwise to START position.
IMPORTANT: If engine fails to start, do not operate starter for more than 30sec at
a time.Turn key back to OFF postion and wait at least 2 minute before trying again,
allow starter motor to cool off.
After engine starts, do not adjust hand throttle lever. Let engine run for 3-4 minute, or if

Table of Contents

Related product manuals