504G3 SERIES TRACTOR OPERATION MANUAL
50
Wait the temperature of coolant decrease to below 70℃.
IMPORTANT: Engine oil provides cooling of certain engine parts. Stopping a
hot engine suddently could damage these parts by overheating or lack of lubrication.
4. Turn key switch to STOP position.Then remove key from key switch to prevent
operation by untrained personnel.
5. If place the tractor on a slop, please pull up the hand brake lever fully.
6. Drain off the cooling water in winter.
CAUTION：
(1) The operator can not leave with the engine on. And it’s necessary to keep the
shuttle and main gear shift levers in neutral.
(2) If the tractor stopped on a slope, the engine must be shut down. At the same time,
shift the shuttle and main speed into gear (upgrade with the shuttle forward and
downgrade with the shuttle reverse). Lock the tires with chocks.
4.2.7DrawtheTractor
1. Turn switch key to OFF position.
2. Place Shuttle shift lever in Netural position, Creer shift lever to “Neutral” position,
Range shift lever in H position, Gear shift lever in “Neutral” position
3. The draw speed must be lower than 18 km/h.
How to draw the tractor
You have tow ways for draw tractor , you can use hook catch B (Bolt weldment) and
also you can put rope to C area: you should take out A (Pin) from B, then take out
B ,and put rope toC area ,then install B and A.
To Next Page
Loading...
