504G3 SERIES TRACTOR OPERATION MANUAL
58
1、Upper jam nut 2、Upper link 3、Lift arm 4、Lift link jam nut
5、Draft link 6、Lift link 7、Sway chain strainer 8、Sway chain pin
4.3.4UseDrawBar
There are three type draw bar for attaching to the tractor.
1、 Disassemble the levers of 3 point hitch system; attach the draw bar (see fig 4-26) to
the tractor. Then remove the pin from draw bar hole and attach trailer to draw bar.
2、 Rear ballast should be disassembled when signal shaft trailer is attach to draw bar.
Fig 4-26
4.3.5PTO
Knegt series tractor PTO shaft adopts linkage type. It can use for move working and also
fix working; Users can choose independent working PTO and
non-independent working
PTO . It’s have hydraulic clutch when choosing the independent working PTO,and when
the users choose non-independent working PTO ,the tractor don’t have hydraulic clutch.
When the tractor need the power take off with an implement, should do as following steps:
(1) Switch off PTO switch so that PTO clutch is disengaged. Place the PTO lever in neutral
position.
(2) Disassemble the draw bar and twist off PTO cover. Then attach the implement to the 3
point hitch system. And link the implement and universal joint and PTO shaft.
(3) Switch on PTO switch so that PTO clutch is engaged. Place the PTO lever in needed
position, Check the operation situation in low speed. Then operate it in normal speed.
Move forward the operation handle, can get high gear 1000 r/min, if move backward,
the low gear 540r/min will reach. When you don’t need the power take off, the operation
handle should be at neutral position, reinstall and fasten the telescopic outer of PTO
To Next Page
Loading...
