504G3 SERIES TRACTOR OPERATION MANUAL
80
②Adjustment of draft control
Unpack the implement and push the position control lever to the end as well as the draft
control lever. Put down the lift links to the ground. Pull the draft control lever until the
lift arms tend to lift. Now the position of the draft control lever should be 5 to 10
degrees to the back end. If it’s bigger the 10 degrees, tighten the adjust nut of draft load
sensing slightly.
NOTE: if the degree is more than 10°, the draft control lever cannot be pushed to the
maximum position or the desired depth cannot be achieve when use both draft control
lever and position control lever.
To Next Page
Loading...
