7/11/2005 VERSION 2.0 15
end and handles of the machine aligned away from any physical interference, such as other equipment,
partitions, or walls.
WARNING:
NEVER force the machine down to match the contour of the mounting surface. Wherever
the machine frame does not meet the mounting surface, use leveling pads or suitable shims to achieve a
solid mount. Forcing the machine frame to twist or warp to conform to an irregular surface will result in
serious loss of alignment and therefore, loss of accurate profile. The machine’s chassis is very rigid, and
leveling pads or shims should be used to retain the original shape of the machine frame when mounting.
8.5.2. Stationary Mounting
For both safety and stability, securely bolt the machine to the mounting surface. Again, ensure the frame is
not cinched down to an irregular base, but rather shimmed to make solid contact at all mounting points.
The first step toward production of high quality profiles is a level, stable machine. Contact the factory for
further information on specific mounting situations. Information is readily available upon request, free of
charge, from the factory.
If the machine is to be mounted to a table, make sure that the table is secured to the floor or ground.
To Next Page
Loading...