7/11/2005 VERSION 2.0 27
11.4.1. Crash Recovery
A crash indicates a serious problem with existing adjustments or some kind of mechanical difficulty. Once
the machine is clear of material, refer to Sections 8 and 9 for Initial Setup and General Operating
Procedures. Re-read Sections 9 and 11 completely. CONDUCT A THOROUGH INSPECTION OF
THE MACHINE, THEN PERFORM ALL THE APPLICABLE PROCEDURES NOTED IN
SECTIONS 9 AND 11. Start from the beginning, as if the machine had not been run. After a crash, all
adjustments are suspect and must be verified.
*** REPLACE THE SAFETY COVERS PRIOR TO CONTINUOUS OPERATION ***
To Next Page
Loading...