WERKZEUGMASCHINEN Operating instructions
KKS 250 / 315 / 350 7/29
Take care about the Power supply cable
Before connecting the power supply cable to the wall socket ensure that the machine
is switched off. Don’t use the cable to pull the plug out of the socket. Take care, that
there is no tensile force on the cable. Beware the power supply cable from heat, oil
and sharp edges.
Control the plug and the cable regular and in case of damage let it repair by the after
sales service. Please control also the extension cable. Never use the machine
without Protection Earth.
Unplug the machine
If you don’t use and while servicing the machine pull off the power supply plug. This
is necessary because the machine should not run unintentionally and to protect you
from electric shock.
Beware of unintentional run
Confirm that the main power switch is off while you plug in the power supply plug.
Be careful with your tools
Keep your tools sharp and clean to work well and secure. Follow the instructions for
tool exchange and servicing.
Don´ t forget tools inside the machine
Before starting makes sure that there are no tools inside the machine which could be
hurled out of the machine. Make sure, that there are no loosen parts witch could be
dangerous.
Take care about your hands
Make sure, that tools and work pieces are securely fastened. Use only the right tools
to clamp and to fasten tools and work pieces. This is more secure than to fasten the
work piece with the hand, and you have two hands to handle the machine.
Pay attention to your balance
Take care about the position of your feed. Never climb on the machine, because
dangerous injury may result from falling down or contacting moving parts.
Accessories and accessory parts
Only use accessories and the operation manual or the supplier specifies accessory
parts witch. The use of other accessories and accessory parts may result in
dangerous injury and damage the machine. Only use accessories and accessory
parts for the right tasks.
To Next Page
Loading...
General