WERKZEUGMASCHINEN Operating instructions
KKS 250 / 315 / 350 9/29
4 Installation
The machine is supplied ready to be used, without cutting blade and emulsifiable
liquid.
When closing the machine position it is convenient to consider:
- That it is free from any hindrances, in a non-damp area, sheltered from the
bad weather
- That it is provided with a good lighting;
- That ft la close to the main switch;
- That the room temperature is between 0° and 45°C.
To carry out the Installation, keep to the following Instruction:
- Screw an M16 threaded eyebolt (minimum capacity load 400 kg.) into the
control handgrip note (7 fig.1)
- Hook the machine by means of ropes and tie rods of suitable carrying capacity
Lifting and handling operations can be very dangerous, if not carefully carried out:
for this reason outsiders must be kept far from the installation area, which is to be
cleaned, cleared out and delimited; ascertain that the available equipment fits the
requirements and Is free of vices; do not handle suspended loads and keep a safety
distance; the loads, during their handling should not be lifted more than 20 cm from
the ground.
- By means of an especially intended crane or hoist lift the machine and place it
in its pre-determined area. Mark, on the ground, the two holes for the machine
fastening to the floor (19 fig. 1)
- Lift the machine again, and place it close by.
- Making use of a suitable drill carry out the two holes and introduce the relevant
- Position the machine and base in its seat and subsequently fasten the base by
means of the two relevant screws
Should the machine be supplied without base, it must be fastened, through the two
holes (18 fig. 1), on suitable frame, able to support the machine weight and any
possible unbalancing resulting from its use.
The manufacturing company decline any responsibility for possible damages caused
by wrong installations or by the use of unsuitable bases.
To Next Page
Loading...
General