16
WARNING
TROUBLESHOOTING
Unplug the tool from the power supply before performing trouble shooting procedures.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Mixer will not
start.
1 Power cord not
plugged in.
2. Power fault, fuse or
circuit breaker tripped.
3. Cord damaged.
4. Faulty switch.
5. Faulty motor.
1 Extension cord too long
or undersized.
2. Tool is overheating.
3. Set at incorrect speed.
4. Carbon brush is worn
out.
5. Tool is overloading
1 Make certain the cord is connected to the
power supply.
2. Check the power supply.
3. Use authorized service center to repair or
replace.
4. Use authorized service center to repair or
replace switch.
5. Use authorized service center to repair or
replace motor.
1 Use extension cord heavy enough to carry
the current.
2. Turn off tool and let it cool to room
temperature. Inspect and clean the
ventilation slots.
3. Make sure the tool is set at the correct speed
to suit for the application and material.
4. Replace with new carbon brush
5. Turn off tool and let it rest a moment and
re-start tool again.
The gear selector is not
in place
Turn the mixer paddle slightly and push the
gear selector. Make sure it is in place.
Carbon brush is worn out
or jammed
Have the carbon brushes checked or
replaced.
Poor working
performance.
Tool turns on,
but the mixer
paddle does
not turn
Frequent or
strong sparks
To Next Page
