11
SAFETY INFORMATION
• Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. The conductor with insulation that has an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor. If repair or replacement is necessary,
do not connect the equipment-grounding conductor to a live terminal.
• Check with qualied electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether
the tool is properly grounded.
• Use only 3-wire extension cords that have 3-prong
grounding plugs and 3-pole receptacles that
accept the tool’s plug.
• Repair or replace damaged or worn cord
immediately.
• This tool is intended for use on a circuit that has
an outlet (sketch B). The tool has a grounding plug
(sketch A). A temporary adapter (sketches D) may
be used to connect this plug to a 2-pole receptacle
(sketch C), if a properly grounded outlet is not
installed by a qualied electrician. The green-
colored rigid ear, lug, and the like, extending from
the adapter must be connected to a permanent
ground, such as a properly grounded outlet.
Specic Safety Warnings for the Router Table
WARNING
• For your own safety, read owner’s manual before using Router or Router Table.
• Always wear eye protection.
• Do not use awkward hand positions.
• Keep ngers away from revolving cutter. Use xtures when necessary.
• Use overhead guard when adjustable fence is not in place.
• Do not expose to rain or use in damp location.
• Risk of re or electric shock. Risk of injury. Total circuit load for the two outlets must not
exceed 15A.
A.
B.
C.
D.
GROUNDED MEANS
GROUNDING
PIN
COVER OF
GROUNDED
OUTLET BOX
METAL
SCREW
To Next Page
Loading...
Need help?
General