18
OPERATING INSTRUCTIONS FOR ROUTER
WARNING
• Before operating the router, follow all safety instructions in this manual. Failure to do so
could result in serious personal injury.
6. ON/OFF Switch
a. To turn the router ON, push the ON/OFF switch
(A) to the “I” for “ON”.
b. To turn it OFF, push the ON/OFF switch to the
“O” for “OFF”.
Always hold the router and cutter bit away from the
workpiece when turning the switch “ON”.
WARNING
• Only allow the router and cutter bit to come into
contract with the workpiece after the router has
reached full speed.
• Only remove the router and cutter bit from the
workpiece after turning the router motor “OFF” and after the cutter bit comes to a complete
stop.
Soft Start Feature
The soft start feature minimizes torque twist, which is common in larger router motors, by
limiting the speed at which the motor starts. This increases the life of the motor.
7. LED Worklights
The router motor has 3 built-in worklights, located
around the collet; these illuminate the cutting area.
These lights are always “on” when the ON/OFF
switch (A) is in the “ON” position.
6
A
7
To Next Page
Loading...
Need help?
General