12
PREPARATION
Know Your Router and Router Table
The xed base router is designed to be used only for straight and grooved milling and the
forming of edges in wood or similar materials. Any other uses of the router not described in this
manual could damage the tool or seriously injure the operator and are, therefore, expressly
excluded from approved applications.
The router table has a precision-built electric switch box and it should only be connected to a
120V~ 60Hz power supply (normal household current). DO NOT operate on direct current. The
large voltage drop would cause a loss of power and the motor would overheat. If the router
table does not operate when plugged into a correct outlet, check the power supply. The router
table comes with a 6 ft. (1.8m) power cord with 3-prong, grounded plug.
WARNING
• To reduce the risk of injury, do not overload the tool. Let it work at its own pace. Guide the
cord carefully to avoid accidentally cutting it.
PREPARATION
K
R
X
A
F
U
B
T
C
G
H I
E
D
S
V
W
J
M
Q
P
O
L
N
To Next Page
Loading...
Need help?
General