OPERATING INSTRUCTIONS
To
add
detergent:
Place pressure washer upright on a flat surface
Remove cap from detergent tank
Pour detergent into tank
Reinstall cap
Detergent
Tank
AcAUTION:
Use
Bl
ac
k Soap Tip Only
Use only approved pressure washer cleane
rs
.
Do
not use bleach, chlorine,or any cleaners containing
acids.
To
use:
Connect low pressure black soap spray tip
to
the wand connector.
Squeeze the trigger and the detergent
will automatically
be
mixed with the water and dispensed
from the spray tip.
NOTE: Use a funnel, if needed, to prevent accidental spilling of the detergent outside
the
tank.
If
any detergent
is
spilled during the filling process, make sure the unit
is
cleaned and dried before
proceeding.
16
OPERATING INSTRUCTIONS
11.STARTING
AND
STOPPING
THE
PRESSURE WASHER
CAUTION:
Do
not
run
the pump without the water supply connected and turned
on
.
Connect the garden
hose.
Turn the water supply
on
, then squeeze the trigger and run water hose
with
motor in OFF position
until a steady stream of water appears. This helps drain air from tank
and
lines.
NOTE: If the pressure washer pulsates and the water stream
is
intermittent turn the pressure washer
off
and
continue to bleed air out of the system. Ensure to check that the garden hose is fully turned
on
and
not kinked.
After ensuring the
On/Off switch is
in
the OFF ( 0 ) position, connect the pressure washer
to
the
power supply.
Press
the reset button
on
the pressure washer's plug to make sure the unit
is
ready for operation.
Rotate to
ON ( I ) position
on
the switch to start the motor.
To
stop the motor, release the trigger and rotate
to
OFF( 0 ) position
on
the switch.
NOTE: The pressure washer may be on and the system may have pressure even when the
pump
and/or motor cannot
be
heard
running. Always use caution around the pressure washer.
CAUTION:
Hold
the trigger handle securely with both hands. Expect the trigger handle
to
move when the trigger
is
pulled due to reaction forces. Failure to do
so
could
cause loss
of
control
and
injury to yourself
and
others.
NOTE: AUTO ON/OFF SWITCH: This pressure washer is equipped with
an
auto start/stop feature.
To
operate: Turn the power switch
to
the
On
(I) position.
Pump
will pressurize
and
shut down
immediately. Once the trigger of the gun is depressed, the unit will turn
on
. Unit will shut off
and
be
in
standby mode when trigger
is
released.
17
To Next Page
Loading...
Need help?
General
