14
ASSEMBLY INSTRUCTIONS
5c. To reill the spool:
a. Cut a length of 0.065 in. (1.65 mm) nylon line
approximately 10 ft. (3 m) long.
b. Insert end of line into the small hole to anchor
the line.
c. Wind the line evenly and rmly in a clockwise direction.
Once completed, put the line in the slot so it does not
unwind. Repeat for the remaining spool section.
d. Do not wind the line beyond the edge of the spool (M).
5e
To Next Page
Loading...
Need help?
General