Kobastar N59 - Page 40

39
 【Ent】: Save; 【Menu】: Exit without saving.
 Repeat the above steps for three times, if the variation of Zero Compensation Coefficient is in
the allowable range, Zero Compensation process will be completed.
 Press key【Pause】to enter Pause state with red sign ‘■’ displaying.
Alarm
Description
Sulution
【Too Small Signal】
AD Value < [Zero Value × 99%].
Do ‘Wheel loader’s Idle Speed Adjustment’
again.
【Z.CMP Limit】
Zero Compensation Coefficient is
not in the allowed range [0.0000~
99.9999].
Do ‘Oil Pressure Sensor Adjustment’ again.