59
Faults
All waves lit up red. The DuoClean has detected a fault.
6.6.5 Recommendations for moisture settings
Hard floor type Dry mode Setting 1 Setting 2 Setting 3
Sealed/varnished wooden floors
(floorboards, parquet)
++ ++ + +
Oiled/waxed wooden floors ++ + – –
Unsealed/untreated wooden floors ++ – – –
Sealed cork floors ++ ++ + +
Oiled/waxed cork floors + – – –
Unsealed/untreated cork floors + – – –
Laminate ++ ++ + +
Elastic floors (PVC, cushion vinyl,
linoleum)
++ ++ ++ ++
Stone floors
(marble, granite, Jura limestone,
artificial stone)
++ ++ ++ ++
Porous/delicate natural stone
(slate, clinker tiles)
++ ++ ++ ++
Clay floors (terracotta, clinker, brick
clay tiles)
++ ++ ++ ++
Ceramic glazed tiles and fine
stoneware
++ ++ ++ ++
Untreated tiled floors + – – –
Rough concrete flooring (washed
concrete)
excluded
Textile flooring excluded
The symbols mean: ++ excellent suitability + good suitability - not suitable
Note:
The optimum moisture setting is also dependent on the speed
with which you work. The quicker you work, the higher the
moisture setting you can select.
If the floor becomes too wet while working with the DuoClean,
you can switch to a lower setting. (Further tips can be found
under Troubleshooting [}64].)
To Next Page
Loading...
