Kobold SPB100 - Troubleshooting

64
8 TROUBLESHOOTING
CAUTION
Risk of injury from moving parts!
Moving parts (such as the rotating brushes or oscillating cloth
holder) could cause injury.
• Always switch the device off before all retrofitting, cleaning and
maintenance work.
• Disconnect the accessory head from the device before performing
retrofitting, cleaning or maintenance work on the accessory head.
• Stay clear of the moving parts.
• Never reach into the rotating components.
Fault Possible cause and solutions
The DuoClean switches
itself off and the LED
waves are lit up red.
It is possible that the motor is overloaded.
– Switch the cordless vacuum cleaner off.
– Switch the cordless vacuum cleaner on.
The DuoClean switches off.
The LED waves are
flashing red and the
inspection flap comes
open.
Moisture has been absorbed.
– Switch the cordless vacuum cleaner off.
– Using a kitchen towel, dry the area of the suction channel
that is exposed by the inspection flap.
– After the device has dried completely, switch on the
cordless vacuum cleaner and close the inspection flap on
the DuoClean.
– This step may need to be repeated several times.
When switching on the
cordless vacuum cleaner,
the LED waves on the
DuoClean flash red.
Moisture may have been absorbed when the device was last
used.
– Switch the cordless vacuum cleaner off.
– Close the inspection flap.
– Switch the cordless vacuum cleaner back on.
It is possible that condensation has formed in the DuoClean as
it was stored at very low temperatures.
– If the DuoClean has been stored in cold conditions, let it
first warm up for several hours at room temperature before
using it.
The suction channel of the
DuoClean is blocked.
– Switch the cordless vacuum cleaner off.