67
Fault Possible cause and solutions
– Press the inspection flap down to close it again.
The magnetic latch on the inspection flap will click into
place and it is now firmly closed.
The cleaning performance
of the
DuoClean worsens.
It is possible that the cleaning cloth is soiled excessively.
– Change the cleaning cloth, see Replacing the cleaning
cloth [}61].
It is possible that the cleaning cloth is too dry.
– Check the LED wave symbol on the DuoClean. If it is lit up
yellow, you need to fill the tank, see Removing, filling and
inserting the tank [}55].
– Moisten the cleaning cloth by pressing the function key,
see Single application of moisture to a dry cloth [}57].
– Also increase the moisture setting if necessary using the
function key, see Automatic application of moisture and
dry mode [}56]
Streaks are forming. It is possible that the cleaning cloth was not washed prior to
first use.
– Wash the cleaning cloth prior to first use, see After use
[}62].
It is possible that too much cleaning agent was used.
– Repeat the cleaning process with a new cleaning cloth and
clean water.
There may be residual quantities of old care products and
cleaning agents on the floor.
– Repeat the cleaning process until it improves; a thorough
clean might be required.
It is possible that the cleaning cloth is soiled excessively.
– Change the cleaning cloth , see Replacing the cleaning
cloth [}61].
– The film of moisture does not dry evenly.
– Go over the floor again using the DuoClean in dry mode
with a dry cleaning cloth to remove residual liquid.
The DuoClean cleans
edges
insufficiently.
It is possible that the cleaning cloth has not been fixed
properly.
– Check whether the cleaning cloth is straight and firmly
fixed on the cloth holder frame.
It is possible that the cleaning cloth was not washed prior to
first use.
To Next Page
Loading...
