69
Fault Possible cause and solutions
– Check the LED wave symbol on the DuoClean. If it is lit up
yellow, you need to fill the tank, see Removing, filling and
inserting the tank [}55].
– Moisten the cleaning cloth by pressing the function key
before continuing, see Automatic application of moisture
and dry mode [}56].
The floor is getting too wet.
– Set the DuoClean to dry mode, see Automatic application
of moisture and dry mode [}56].
– Continue working without the automatic moistening
function for the time being until the floor appears to be
drying.
– Then set the DuoClean to moisture setting 1, see
Automatic application of moisture and dry mode [}56].
If the fault cannot be rectified, please contact Vorwerk customer
service, see Service [}70].
To Next Page
Loading...
