8
TROUBLE SHOOTING
If you have any problems with your shredder, check the symptoms and solutions below. If this fails to solve the problem,
contact your nearest Kobra dealer.
Do not open the head of the shredder to try to repair it yourself. You could expose yourself to the risk of serious
electrical shock and also invalidate your guarantee.
PROBLEM WHAT YOU SEE CAUSE ACTION
The shredder does not
start up
- The ENERGY SMART Optical
indicator light (B) does not
come on
- Switch is in (A) position.
- Waste paper bin (2) not
positioned properly on the
STAND (4)
- Change switch to FWD position.
- Push the paper bin fully into the
stand.
- ENERGY SMART Optical
indicator light (B) comes on
- Motor in overheat
protection mode
- Wait 15 minutes for the motor
to cool down.
- The machine fails to start when
paper is inserted into the throat
- Cable not connected
properly
- No electrical power
- Check that the plug is plugged
into the socket correctly.
- Check that there is power to the
socket.
The shredder never
stops
- Optical Indicator Light (B) is on,
blades operating
- Material and/or dirt
deposited on photocells (C)
- Remove deposit from
photocells.
Notable reduction in
shredding capacity
(only on Kobra +1CC4)
- Reduced capacity compared
with oiled cutting blades
- Cutting blades not oiled - Oil the cutting blades.
Declaration of conformity
in aCCordanCe witH: - direCtive lvd 2006/95/Ce
-
direCtive 2011/65/eU roHS
-
direCtive 2004/108/Ce Cem
t
He manUfaCtUrer: elComan Srl
EN 60950-1:2006 / A11:2009 /A1:2010/A12:2011
EN 55014-1 :2006
EN 55014-2 :1997 + A1 :2001
EN 61000-3-2 :2000/A2 :2005
E N 6 1 0 0 0 - 3 - 3 : 1 9 9 5 / A 2 : 2 0 0 5
EN 61000-4-2 :1995/A2 :2001
EN 61000-4-3 :2006
EN 61000-4-4 :2004
EN 61000-4-5 :2006
EN 61000-4-6 :1996/A1 :2004
E N 6 1 0 0 0 - 4 - 1 1 : 2 0 0 4