Kodak EasyShare DX6340

34
Chapter 2
Setting Exposure Metering
Use Exposure Metering to ensure that the proper amount of light enters the
camera lens.
NOTE: Exposure Metering is available in Landscape, Close-up, and PAS modes.
1 In any Still mode, press the Menu button.
2 Press to highlight Exposure Metering , then press the OK
button.
3 Press to highlight an option, then
press the OK button.
Multi-pattern (default)—evaluates
lighting conditions throughout the image
to give an optimum picture exposure.
Ideal for general picture taking.
Center-weight—evaluates the lighting
conditions of the subject centered in the
viewfinder. Ideal for backlit subjects.
Center-spot—similar to
Center-weighted, except the metering is
concentrated on a smaller area of the
subject centered in the viewfinder. Ideal
when you need an exact exposure of a
specific area in the picture.
4 Press the Menu button to exit the menu.
This setting remains until you change the
Mode dial or turn off the camera; or, if it
was set while in PAS mode, until you use
Reset (page 36) to return to the default
setting.