Kodak EasyShare printer dock User Manual

48
Chapter 7
Battery Charging Lights
Light Status Cause Action/Solution
No lights Camera is not properly seated in
the printer dock.
Place the camera in the
printer dock (page 13) or
readjust the camera
placement.
Camera is turned on. Turn off the camera.
Correct battery is not installed. Install a Kodak EasyShare
Ni-MH rechargeable battery
pack or Kodak EasyShare
Li-Ion rechargeable battery
(page 11).
Green lights
Battery is less than half charged. Leave camera on dock to
continue charging.
Battery is more than half charged.
Battery is fully charged. Leave camera on the dock
to maintain charge.
One green
light
Camera was placed in camera
dock.
None; dock is checking the
charge status of the battery.
Red light
(blinking)
Battery is not properly installed. Re-install the battery.
Battery or connector pin is
damaged.
Check for damage.
Camera and battery have been
exposed to extreme
temperatures.
Slowly return the camera
and battery to room
temperature.
urg_00041.book Page 48 Monday, August 18, 2003 10:02 AM

Kodak EasyShare printer dock Specifications

General

Print Resolution	300 x 300 dpi
Supported Paper Size	4 x 6 inches
Connectivity	USB
Compatibility	Kodak EasyShare cameras
Print Speed	Approximately 90 seconds per print
Power Source	AC adapter
Print Technology	Dye Sublimation