Getting started
www.kodak.com/go/support
7
3 Set the clock.
Tap the down arrow to highlight Clock, then
slide or tap between the left/right arrow lights to
select the current time (based on a 24-hour clock).
4 Set the date.
Tap the down arrow to highlight
Year/Month/Day, then slide or tap between the
left/right arrow lights to select the current date
(three separate settings).
5 Set Energy saver.
Energy saver automatically turns off the frame after 16 hours of play. You can
change the time to 8 hours or disable the feature.
■ Tap the down arrow to highlight Energy saver, then slide or tap between
the left/right arrow lights to select 8 or 16 (default) hours. To disable Energy
saver, select 24 hours.
NOTE: Energy saver is disabled when you set the automatic On/Off Timer.
Energy saver is available on frames with firmware dated September 2009 or later. To check your
frame’s firmware version and date, see page 34, Settings, About this frame.
6 Set automatic on and off times.
Specify the times you want your frame to automatically turn on and off.
NOTE: Make sure the on time is earlier than the off time.
a Tap the down arrow to highlight On/Off Timer, then tap a left/right arrow
light to change the option to Enabled.
b Tap the down arrow to highlight Turn Frame On At, then slide or tap between
the left/right arrow lights to select the On time (based on a 24-hour clock).
Slide between the arrow lights.
Press and hold to move quickly
through the time and date
settings.
To Next Page
Loading...
