10 | EN
ADJUSTING FOCUS
PAIR THE REMOTE CONTROL
If the image on the screen appears fuzzy or unfocused when you turn the projector on,
use the focus wheel on the top to correct the image. Move the wheel left or right until
the image appears sharp and clear.
NOTE: For best performance, the projector must be located a minimum distance of 3.5
feet (1 meter) from the screen.
Power on the projector and the remote control should automatically pair with the
projector.
For manual pairing, press and hold the Volume – and OK buttons simultaneously for ive
(5) seconds. The LED light on the remote control will begin to lash. When the pairing
is complete, the LED light on the remote control will remain on without lashing. You
should now see a blue checkmark on your screen. Remember to always point your
remote control towards the projector and not the screen.
To Next Page
Loading...
