EN | 9
INSTALL BATTERIES INTO THE REMOTE CONTROL
SET UP THE PROJECTOR
1. Press down and slide o the
battery cover.
2. Insert the two (2) AAA batteries
into the battery compartment.
3. Place the battery cover back on
the remote control.
1. Place the projector in front of a suitable projection screen or wall.
2. Connect the AC adapter to the power cord.
3. Then, connect the power jack of the AC adapter to the projector.
4. Connect the wall plug of the power cord to a wall outlet. The LED indicator on the
back of the projector will light up red.
5. Press the Power button on the projector or remote control to turn on the device.
The LED indicator will then turn green.
To Next Page
Loading...
